How to Get Rid of Black Mold in House

How to Get Rid of Black Mold in House

Posted on

Moldy or mossy walls can be a disgrace to the house and its inhabitants. The color is never seen, the smell is stinging, the roots damage the wall, not to mention the risk of spores being inhaled. Overcome this problem with home cleaning products before going too far. In addition to removing mold and mildew, the most important thing after that is to prevent it from appearing again.

Why do mold and mildew grow on the wall?

The fungus grows from spores that spread through the air. The fungus usually grows in a humid, warm, and does not have good air circulation. Therefore, the bathroom is prone to mold. Sometimes it can be tried by damp conditions and lack, but it can also be caused by air seepage – both ground air, rain air, and leakage pipes. AC that is not properly correct also causes mold due to water droplets.

Moss doesn’t always look green as often found outside the home. On the wall, moss can be dark gray or even black. Moss quickly spreads to a wider area if not immediately carried out. To finish you, use a cloth soaked in carbolic on a dark part. If the dark color is only a few minutes, then the dark color is moss. If not, the spot might just be dirt.

How to remove the shower sheath

To prevent unwanted things, wear rubber gloves, long-sleeved clothes, and mouth and nose masks. Open a window during this task.

  1. Make a solution of carbolic and air mixtures – usually with a dose of 1 part carbolic and 3 parts air. If karbol is not available, you can use detergents that use cloth lightening.
  2. Use or sprinkle prices on moldy areas.
  3. Rub the moldy parts to hold the towel when rough or rough fibrous cloth.
  4. Rinse thoroughly then dry.

If the steps are not successful, use products specifically designed to eradicate mold and mildew on the wall. These products study harder substances, so do not mix one product with another because it can cause dangerous reactions.

Tips to prevent mold and mildew

After you handle moldy and mossy walls, of course you don’t want this wall disease to reappear. Here’s how to prevent it:

  1. Buy special products to inhibit the growth of mold and mold. Antimicrobial sprays prevent mold spores from settling on the wall. Consider replacing your wall paint with waterproof wall paint and mushrooms that have multiple advantages. First, the basic material that is water repellent allows it to be washed or wiped using a wet cloth. Second, because the water that seeps into the wall is very minimal, the walls are always dry so the fungus is reluctant to grow. This also applies to anti-moss wall paint.
  2. Use a dehumidifier to reduce humidity in the room that is very prone to mold and mold. This tool can be a long-term preventive measure.
  3. Fix the gutter channel from the water from the tile. Make sure the gutter layer does not leak, replace or repair if it is damaged, and clean the dirt so that it does not clog the flow of water, including the pipes that deliver water from the gutters to the ground.
  4. Maintain that the bathroom, kitchen and other humid locations have smooth and always dry air circulation.
  5. Dry the towel and shower curtain.
  6. Handle leaks in the water pipe as soon as possible, especially if the pipe is near or planted inside the wall.

Leave a Reply

Your email address will not be published. Required fields are marked *

5 − three =